TALE 78

The Fish and the Pond

[Ill.u.s.tration: The Fish and the Pond--and the Cone]

Go out and get the cone of a Norway Spruce tree, or a White Spruce; this is the body of your Fish. Cut two round spots of white paper for eyes, glue them on, and when dry, put a black ink spot in the middle of each.

Add a curved piece of paper on each side for gills. Then with an awl or with the point of the scissors make holes in the sides, in which put fins cut out of brown paper, fixing them in with glue. Then, with the knife blade, make a long cut in the back, and split the tail, and in each cut glue a thick piece of brown paper cut fin shape. When dry, draw lines on these with ink. Now you have a good Fish.

For the pond, take a cigar-box, paint the lower quarter of it dark green, and the upper part shaded into light blue, for sky. Glue a piece of gla.s.s or else carwindow celluloid level across this near the bottom.

This is for water. Hide all the back and side edges of the gla.s.s with clay banks as described in the Monkey-hunt, or with moss glued on. Put a fine black thread to the Fish's back, another to his tail, and hang him level above the water by fastening the threads to the top of the box. Label it "Pond Life" or the "Fish at Home."

TALE 79

Smoke Prints of Leaves

[Ill.u.s.tration: Smoke Prints of Leaves]

Collect one or two leaves that have strongly marked ribs; elm and raspberry are good ones. Take a piece of paper that is strong, but rather soft, and about as big as this page. Grease, or oil it all over with paint-oil, b.u.t.ter, or lard. Then hold it, grease-side down, in the smoke of a candle, close to the flame, moving it about quickly so that the paper won't burn, until it is everywhere black with soot.

Lay the paper flat on a table, soot-side up, on a piece of blotting paper. Lay the leaf on this; then, over that, a sheet of paper. Press this down over all the leaf. Lift the leaf and lay it on a piece of soft, white paper; press it down as before, with a paper over it, on which you rub with one hand while the other keeps it from slipping; lift the leaf, and on the lower paper you will find a beautiful line-drawing of the leaf, done in black ink; which, once it is dry, will never rub out or fade away.

At one corner write down the date and the name of the leaf.

TALE 80

Bird-boxes

[Ill.u.s.tration: Bird-boxes]

You can win honours in Woodcraft if you make a successful bird-box. That is one made by yourself, and used by some bird to raise its brood in.

There are three kinds of birds that are very ready to use the nesting places you make. These are the Robin, Wren, and Phoebe. But each bird wants its own kind exactly right, or will not use it.

First the Robin wants a shelf, as in the picture. It should be hung against a tree or a building, about ten feet up, and not much exposed to the wind. It should also be in a shady place or at least not where it gets much sun.

The nails sticking up on the floor are to hold the nest so the wind will not blow it away. The Phoebe-shelf is much the same only smaller.

The Wren-box should be about four or five inches wide and six inches high inside, with a hole exactly seven eighths inch wide. If any bigger, the Wren does not like it so well, and other birds may drive the Wren away. Many Wren-boxes are made of tomato tins, but these are hard to cut a hole in. The Wren-box should be hung where the sun never shines on it all summer, as that would make it too hot inside.

TALE 81

A Hunter's Lamp

[Ill.u.s.tration: A Hunter's Lamp]

In the old pioneer days, every hunter used to make himself a lamp, for it was much easier to make than a candle. It is a good stunt in Woodcraft to make one. Each woodcrafter should have one of his own handiwork. There are four things needed in it: The bowl, the wick, the wick-holder and some fat, grease, or oil.

For the bowl a big clam sh.e.l.l does well.

For wick a strip of cotton rag rolled into a cord as thick as a slate pencil, and about two inches long; a cotton cord will do, or perhaps the fibrous bark of milkweed or other native stuff is the truly woodcraft thing.

For wick-holder get a piece of brick, stone, or a small clam sh.e.l.l about as big as a half dollar. Bore a hole through the middle to hold the wick. It is not easy to get the hole through without splitting the stone, but sometimes one can find a flat pebble already bored. Sometimes one can make a disc of clay with a hole in it, then burn this hard in a fierce fire, but the most primitive way is to rub the b.u.mp of a small clam sh.e.l.l on a flat stone till it is worn through.

For oil use the fat, grease, lard, or b.u.t.ter of any animal, if it is fresh, that is without salt in it.

Fill the bowl with the grease, soak the wick in grease and set it in the holder so that half an inch sticks up; the rest is in the grease. The holder rests on the bottom of the bowl.

Light the end that sticks up. It will burn with a clear, steady light till all the oil is used up.

To have made a lamp that will burn for half an hour is counted an "honour" in Woodcraft, and may win you a badge if you belong to a Woodcraft Tribe.

TALE 82

The c.o.o.n Hunt

Take a little bundle of white rags, or paper, as large as a walnut; call this the "c.o.o.n." While all the young folks hide their eyes or go out of the room, the Guide puts the c.o.o.n on some place, high or low, but in plain view; then, going away from it, shouts "c.o.o.n!"

Now the young scouts have to find that c.o.o.n, each looking about for himself. As soon as one sees it, he says nothing, but sits down. Each must find it for himself, then sit down silently, until all are down.

Last down is the "b.o.o.by"; first down is the winner; and the winner has the right to place the c.o.o.n the second time, if the Guide does not wish to do it.

This is often played indoors and sometimes a thimble is used for the c.o.o.n.

TALE 83

The Indian Pot

This is something everyone can make, no matter how young, and each, including the Guide, should make one.

Get a lump of good stiff clay; yellow is better than blue, only because it is a better colour when finished.

Work the clay up with water till soft, pick out all stones, lumps, and straws. Then roll it out like a pancake; use a knife to cut this into laces a foot long and about as thick as a pencil.

Dip your fingers in water, take one of these laces and coil it round and round as in "a," soldering it together with water rubbed on and into the joints. Keep on adding, shaping and rubbing, till you have a saucer about three inches across and a quarter of an inch thick. Put this away in some shady place to set, or harden a little; otherwise it would fall down of its own weight.

After about an hour, wet the rim, and build up on that round and round with laces as before, until you have turned the saucer into a cup, about four inches across, and, maybe three inches high. Set this away to stiffen. Then finish the shape, by adding more coils, and drawing it in a little. When this has stiffened, make a "slip" or cream of clay and water, rub this all over the pot inside and out; use your fingers and a knife to make it smooth and even. When this is done, use a sharp point, and draw on the pot any of the Indian designs show in the sketches, using lines and dots for the shading.

[Ill.u.s.tration: The Indian Pot]

Now set the pot in some shady place to dry. High above the stove in the kitchen is a good place, so long as it is not too near the stove-pipe.

After one day bring it nearer the heat. Then about the second day, put it in the oven. Last of all, and this is the hardest part to do, let the Guide put the bone-dry pot right into the fire, deep down into the red coals at night, and leave it there till next day. In the morning when the fire is dead, the pot should be carefully lifted out, and, if all is well, it will be of hard ringing red terra cotta.

The final firing is always the hardest thing to do, because the pots are so easily cracked. If they be drawn out of the fire while they are yet hot, the sudden touch of cold air usually breaks them into pieces.